BTZS.org >> Forums home page
 
 General Discussions
 General Discussions

Announcements | General Discussions | Plotter | ExpoDev Palm | Film & Paper Testing | Practical BTZS | ExpoDev for iOS



 
Messages 51 to 60 of 316 (Total: 316) First | Prev | Next | Last
Subject 
Author 
Date 
Re: Spot meter 
Steve Nicholls  15:12 12 Nov 07 
I tend to agree with what you are saying Ben however the Expodev as it is set up requires a [for want of a better term] low zone and high zone value.

So how do you approach a subject with a spot meter as putting a low reading on z 2 - 3 or even 4 will make a major difference to the image. As will where the highest reading is placed.

With incident basically the shadow reading is the lowest dark value with a touch of detail so with the expodev is that a z3 or a z2

I fully understand SBR's but also wish to get a detailed full range print so where the low value is placed has a very strong impact on the image.

If you have an example of how you go about the use of the spot meter I would be interested to know

Steve
 
Using a flash for testing.  
Jorge Gasteazoro.   10:13 7 Nov 07 
Re: Using a flash for testing.  
Ben Wilbur  10:58 7 Nov 07 
Re: Using a flash for testing.  
Jorge Gasteazoro.   11:22 7 Nov 07 
Re: Using a flash for testing.  
Ben Wilbur  14:41 7 Nov 07 
Re: Using a flash for testing.  
Jorge Gasteazoro.   14:55 7 Nov 07 
Re: Using a flash for testing.  
Barry Wilkinson  2:16 8 Nov 07 
Re: Using a flash for testing.  
Miles Nelson  20:01 8 Nov 07 
Re: Using a flash for testing.  
Philippe Bedfert  4:50 8 Nov 07 
Re: Using a flash for testing.  
Jorge Gasteazoro.   6:14 8 Nov 07 


BTZS.org >> Forums home page
 
 Note: The BTZS.org forums are now in read-only mode Last Updated: 22 Aug 2002